Please note that this software is for Framework Laptop 13 (AMD Ryzen™ AI 300 Series) ONLY!

For other Framework Laptops, please read the article located HERE.

You can check your current BIOS version following the steps here to determine if you are on the latest release.

Please note this is the initial version shipped from the factory. 

Downloads

Windows

Instructions for Windows Installer:

1. Run the .exe.

2. Click yes to reboot.

3. Wait for the firmware progress bar to complete, and then the system will reboot.

4. If you are updating a system in standalone mode, please pay careful attention to the standalone update process below.

Please note that you must update with a charger attached. 

Linux/LVFS

Please note that you must update with a charger attached, then run:

fwupdmgr refresh --force

then

fwupdmgr get-updates

then

fwupdmgr update

Please note that you must update with a charger attached. 

LVFS may not update if the battery is 100% charged. LVFS uses the battery status to determine if it is safe to apply updates. However if our battery is at 100% and the charger is off, we set the battery charging status to false. In this case you can discharge your battery a few percent, then plug in AC again and run fwupdmgr update.

EFI Update

Note that if you use the EFI shell update with Windows, you should suspend Bitlocker if enabled before updating using the EFI updater.

Instructions for EFI shell update

1. Extract contents of zip folder to a FAT32 formatted USB drive. Cleanly unmount the drive before physically removing it, otherwise the BIOS update may not function correctly. 

2. Boot your system while pressing F12 and boot from the thumb drive.

3. Let startup.nsh run automatically.

4. Follow the instructions to install the update.

Component Versions

This BIOS update is a bundle of updates to multiple embedded components in the system.

Not all of them use the same version number.

Driver Bundle

Windows 24H2

Driver Bundle Components